Manual

Whirlpool - CIC 8/16/04 2:25 PM PAGE 1/21 RightFax
green green black white
ground ground wir_ win=
white ecrew wires (from (from
wire_ blowed blower}
"brown wire
(from hood
liner)
\ blue wire
(from hood
liner)
power blower
hood liner supply wiring
wiring cablo
Connect both green ground wires
(from exterior blower motor and
from 120-volt supply wiring)
under the unused green ground
screw.
120-volt supply wiring:
* Connect 120-volt black supply
wire to black hood tiner wire with a
twist-on connector.
• Connect 120-volt supply white
wire with to white hood liner
wire with a twist-on connector.
Exterior blower motor wiring:
• Connect the black blower motor
wire to the blue hood liner wire
with a twist-on connector.
• Connect white blower motor
wire to brown hood liner wire
with a twist-on connector.
3. Tighten strain reliefscrews.
4. Replace widng box cover.
Tightenscrew securely.
5= Connect exteriorblower
vent systemto hood linercollar.
Sealjointwith duct tape to make
airtight.
6= Reconnect power.
_d
light blower motor
switch _witch
7= Check operationof hood
linerand exteriorblower.
Lights:
• Move the light switch to "1"
position. Lights should go on.
Move switch backto "0"
position. Lights should go off.
Exterior blower motor and speed
control:
• Move motor switch to "1"
position. Exterior blower motor
should turn on.
• Move speed control switch to
vary the blower speed from low
(at the left) to high (at the right).
• Move speed control switch back
to low (at the left). Move the
motor switch backto "0"and the
blower motor should turn off.
8, Reinstallfilters. Place back
edge offilter'intochannelat rearof
hood liner.Pushfilter upwhile
pushingtab back. When filteris in
place,releasetab, Lockingpin will
holdfilterin place. Repeat with
otherfilter(s).
9. Installfront enclosure.
To get the most efficient use from
your new hood liner, read the
"Use and Care Information"
section. Keep your KitchenAid
Installation Instructions and Use
and Care Guide close to hood
liner for easyreference.