Installation Instructions

6
Mounting the Water Valve
NOTE: When using this kit to replace an existing ice maker or
valve, the new valve and the new ice maker from this kit must
both be used.
1. Remove valve cover screw (A) using 1/4" nut driver. Retain
screw. Detach harness from the inner side of cover by
removing the clip. Discard cover.
2. Remove 6-9 screws (B) from rear panel. Remove strain relief
from slot (C). Remove panel.
3. Locate the 2-pin water valve connector inside the machine
compartment. Determine which of the two included water
valves has the appropriate connection to mate with this
connector. Discard the other water valve.
4. Insert top of valve chosen in step (3) through slot in rear
panel, then rotate so the bracket is at against the panel.
5. Assure water valve bracket is placed into retainer tab (A) and
secure to panel with screw (B) removed in step 1.
6. Slide water line guide into rear panel slot below valve, as
shown in illustration.
7. Insert water line from ll tube into water line guide opening.
Loop tube under the bottom of rear panel and insert into
water valve nozzle.
NOTE: Make sure tube is fully inserted into valve, past the
rst marking on the tube.
8. Pull excess water line tubing taut against the U-channel (A) in
the water line guide.
Matching harness connector to valve
Inserting the valve
Securing the valve
A
B
C
Valve cover and rear panel screws
A
B
A
B
Water line guide installation
Inserting water line into guide
A
B
B
B
Inside view of rear panel