Owner's Manual

12
NOTE: At any filter status, pressing and holding the Air Filter
button for 3 seconds will reset the air filter status to Good and the
air filter icon will turn off.
Replacing the Air Filter
The disposable air filter should be replaced every 6 months, or
when the status indicator air filter icon turns on and starts flashing
when the refrigerator door is opened.
To order a replacement air filter, see ordering information in the
Quick Start Guide.
1. Remove the used air filter by squeezing in on the side tabs.
2. Install the new air filter and status indicator using the
instructions in the previous sections.
Air Filter Status Indicator—Standard Installation
The filter comes with a status indicator, which should be activated
and installed at the same time the air filter is installed.
1. Place the indicator facedown on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator, until
the bubble pops to activate the indicator.
3. Lift open the vented air filter door. On some models, there are
notches behind the door.
On models with notches:
� With the indicator screen facing outward, slide the indicator
down into the notches.
NOTE: The indicator will not easily slide into the notches if the
rear bubble has not been popped.
� Close the air filter door, and check that the indicator is visible
through the window in the door.
A. Status indicator window
B. Air filter status indicator
C. Notches
� Place the indicator in a visible place you will easily remember
either inside the refrigerator or elsewhere in your kitchen or
home.
Replacing the Air Filter
The disposable air filter should be replaced every 6 months, when
the status indicator has completely changed from white to red.
To order a replacement air filter, see ordering information in the
Quick Start Guide.
1. Remove the used air filter by squeezing in on the side tabs.
2. Remove the used status indicator.
3. Install the new air filter and status indicator using the
instructions in the previous sections.
Install Produce Preserver (on some
models)
Your refrigerator's accessory packet includes a Produce
Preserver, which should be installed prior to use. On some
models, the Produce Preserver is already installed at the factory.
To order a replacement produce preserver, use part number
W10346771.
The Produce Preserver absorbs ethylene, allowing the ripening
process of many produce items to slow down. As a result, certain
produce items will stay fresh longer.
Ethylene production and sensitivity varies depending on the type
of fruit or vegetable. To preserve freshness, it is best to separate
produce with sensitivity to ethylene from fruits that produce
moderate to high amounts of ethylene.
Sensitivity to
Ethylene
Ethylene
Production
Apples High Very High
Asparagus Medium Very Low
Berries Low Low
Broccoli High Very Low
Cantaloupe Medium High
Carrots Low Very Low
Citrus Fruit Medium Very Low
Grapes Low Very Low
Lettuce High Very Low
Pears High Very High
Spinach High Very Low
Installing the Produce Preserver
CAUTION: IRRITANT. MAY IRRITATE EYES AND SKIN.
DANGEROUS FUMES FORM WHEN MIXED WITH OTHER
PRODUCTS.
Do not mix with cleaning products containing ammonia, bleach,
or acids. Do not get in eyes, on skin or clothing. Do not breathe
dust. Keep out of reach of children.
FIRST AID TREATMENT: Contains potassium permanganate. If
swallowed, call a Poison Control Center or doctor immediately.
Do not induce vomiting. If in eyes, rinse with water for
15 minutes. If on skin, rinse with water.
Style 1–Located Inside the Refrigerator:
1. Find the Produce Preserver housing inside the refrigerator.
2. Lift up on the housing to remove it from the mounting tab.