Owners Manual

19
To Remove the Handles:
1. While holding the handle, insert the short end of the hex key
into the upper hole and slightly rotate the hex key until it is
engaged in the setscrew.
2. Using a counterclockwise motion, loosen the setscrew a
quarter-turn at a time.
3. Repeat steps 1 and 2 for the upper setscrew. Gently pull the
handle away from the door.
4. If necessary, use a Phillips screwdriver to remove the shoulder
screws from the door.
Remove Doors and Hinges
If your refrigerator does not fit through the doorway or you are
getting rid of your old refrigerator, follow the steps below for door
removal.
WARNING
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so could result in death or electrical shock.
1. Unplug refrigerator or disconnect power.
2. Fully open both doors.
3. If your model has water dispensing, please open the water
filter door by pulling it toward you as shown below. It is not
necessary to remove the water filter itself.
4. Pull the base grille toward you from the sides and then from
the center until it dislodges.
5. To remove the base grille, twist and pull the right side until this
side passes underneath the refrigerator door. Then pull the left
side of the base grille for complete removal.
6. If your model has water dispensing in the door, disconnect the
water dispenser tubing located below the freezer door.
� Press the blue outer ring against the face of fitting and pull
the dispenser tubing free as shown below.
NOTE: Keep the water tubing connector attached to the
tube that runs underneath the freezer. The door cannot
be removed if the connector is still attached to the tube
that runs through the door hinge.
A. Face of fitting
7. If your model has water dispensing in the door, disconnect the
wiring located below the freezer door as shown below.
� Remove the wiring clip and the bracket wire using a 1/4"
hexagonal-head socket wrench.
� Disconnect the wiring plugs from the bracket wire.
A. Wiring plugs C. Grommets
B. Wiring clip
8. Close the freezer door and use a TORX T30 screwdriver to
remove the top hinge completely as shown below.
A. Do Not Remove Screws
IMPORTANT: Do not remove either screw A. Hold the door
while hinge is being removed.