Owners Manual

20
9. Lift the freezer door straight up off from the bottom hinge as
shown below. The water dispenser tubing and wiring will
remain attached to the freezer door.
WARNING
Excessive Weight Hazard
Use two or more people to lift the appliance door.
Failure to do so can result in back or other injury.
NOTE: This may require two people, one to lift the door
and the other to feed the water tubing and wiring into the
bottom hinge pin.
IMPORTANT: Rest the door on its side on a soft, clean
surface, such as a towel, blanket, or piece of cardboard. This
will help to avoid scratching or damaging the door, water
tubing, and wiring.
10. Close the freezer door and use a TORX T30 screwdriver to
remove the top hinge completely as shown below.
A. Do not remove screws.
IMPORTANT: Do not remove either screw A. Hold the door
while hinge is being removed.
11. .Lift the refrigerator door straight up off from the bottom hinge
as shown below.
IMPORTANT: Rest the door on its side on a soft, clean
surface, such as a towel, blanket, or piece of cardboard. This
will help to avoid scratching or damaging the door.
12. If your refrigerator without doors does not pass through the
doorway, you may remove both bottom hinges. Use a 5/16"
nut driver to remove these as shown below..
B. Do not remove B screws
IMPORTANT: Do not remove either screw B.
Replace Doors and Hinges
If your doors and bottom hinges have been removed, please
follow the next instructions for reinstallation:
1. Reinstall both bottom hinges using a 5/16" nut driver to tighten
screws as shown below.
B. Do not remove B screws
2. If your model has water dispensing in the door:
� Lift the freezer door enough to feed the water dispenser
tubing and wiring through the bottom hinge pin as shown
below.
NOTE: This may require two people, one to lift the door
and the other to feed the water tubing and wiring into
the bottom hinge pin.
IMPORTANT: Hold the door while hinge is being installed.