Installation Instructions
20
4. Turn gas pressure regulator cap counterclockwise with
a 5/8" (1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the solid end faces out and the marking
“ê NG” is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Propane Gas to Natural
Gas)
1. Remove burner cap.
2. Remove the burner base.
A
B
C
D
Side view before
Side view after
E
NG
LP
LP
NG
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing out
C. Gas pressure regulator cap with solid end facing out
D. Washer
E. Gas pressure regulator cap
D
E
C
B
A
A. Burner cap
B. Burner base
C. Alignment pins
D. Igniter electrode
E. Gas tube opening
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orice spud in the nut driver while changing
it. Press nut driver down onto the gas orice spud and remove
by turning it counterclockwise and lifting out. Set gas orice
spud aside.
4. Gas orice spuds are stamped with a number on the side or
top. Replace the Propane gas orice spud with the correct
Natural gas orice spud.
Refer to the following chart for the correct Natural gas orice
spud placement.
Natural Gas Orice Spud Chart
Burner Rating Size (mm) ID Number
19,000 BTU (ST) 1.96 196AM
17,000 BTU (ST) 1.84 184AM
17,000 BTU 1.96 196AM
15,000 BTU 1.75 175AM
9,200 BTU 1.35 135AM
8,000 BTU 1.25 125AM
5,000 BTU 1.00 100AM
1,450 BTU 0.53 053AM
NOTE: Refer to the model/serial/rating plate located on the oven
frame behind the top right-hand side of the oven door for proper
sizing of spuds for each burner location.
5. Place Propane gas orice spuds in the orice spud bag.
IMPORTANT: Keep the Propane gas orice spuds in case
of reinstallation with Propane gas.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1 to 7 for the remaining burners.
To Convert Oven Bake Burner (Propane Gas to
Natural Gas)
1. Remove the oven racks and the oven door. See the “Oven
Door” section.
2. Remove 2 screws and washers at the rear of the oven
bottom.
A
B
C
D
A. Igniter electrode
B. Orice spud
C. Orice spud holder
D. Screws
XXX
A
XXX
A. Stamped number