Kitch _n_kid ® COMPACTOR For questions about features, operation/performance, In Canada, call for assistance 1-800-461-5681, parts accessories for installation www.kitchenaid.com or service, call: 1-800-422-1230 and service, call: 1-800-807-6777 or visit our website at... or www.KitchenAid.ca Table of Contents ............................................................................................................
TABLE OF CONTENTS COMPACTOR SAFETY .............................................................. INSTALLATION INSTRUCTIONS .................................................. Unpacking .................................................................................... Location Requirements ................................................................ Electrical Requirements ............................................................... Undercounter Installation .........................................
4, INSTALLATION INSTRUCTIONS Installer: Place the other two corner posts on the floor to the side of the compactor. Grasp the sides of the compactor cabinet and put compactor on its side on top of the corner posts. Remove the shipping base from the bottom of the compactor. Leave Use and Care Guide with the homeowner. Homeowner: Keep Use & Care Guide for future reference and for local electrical inspector's use, if required. 1. Leveling legs 2.
Cutout dimensions \ 3J_ (7.6 cm)_=._ 34_h" rain. (87 cm) 18" min. (45,7 cm) I_ 151/4"min. (38.7 cm) 1. Grounded electrical outlet must be a minimum of 3 in. (7,6 cm) away from surrounding cabinets or nearby walls as shown. It can be placed either to the left or the right side of the product. Clearance Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Failure to follow these instructions can result in death, fire, or electrical shock. 24" min.
NOTE: Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the personal responsibility and obligation of the customer to contact a qualified installer to assure that electrical installation meets al( National and Local codes and ordinances. Tools and materials needed for installation: 2. Use pliers to lower leveling legs away from cabinet. Adjust legs so there will be a I/8 in. (3 mm) to 1/4in. (6.
Cabinet-front Installation mounting 1. Mounting 2. Cabinet 1. Align the bottom of the custom panel with the bottom of the drawer front. 2. Secure the panel from the back using 4 - #8 x 1 in. wood screws as shown. 3. Attach a 15 in. x I/2 in. quarter-round drawer front using glue or screws. filler along the top of the clip 3. Retaining bracket 4. Mounting screw 8. Grasp sides of compactor drawer and place bottom of drawer into tracks. Lift at the handle so drawer will go over drawer stops.
Load bulky trash, bottles, and cans in the center of the drawer. Bottles or cans not placed in the center may become caught between the ram and the drawer. The Drawer Monitor Switch then senses a "misload" and causes the ram to return to the "up" position without compacting. 3. Close the drawer. 1. Open container. Load trash. 2. Leave Key-Knob in ON position. 3. 4. Set Solid pack switch to OFE Close container. 5. Lift foot pedal UP to START cycle.
Whenthetrashiscompacted tothetopofthedrawer, remove thebag.Ifthebagistooheavy, compact lesstrashbefore emptying it inthefuture. IMPORTANT: Before installing a new bag, be sure: • The drawer side is securely locked. • The container is clean and free of debris. Do not use any kind of bag other than those designed especially for use in your compactor. Order replacement compactor bags through your local dealer or by calling the toll-free number on the cover or in the "Assistance or Service" section.
2. Remove the Air Filter by pulling the top edge of the filter. The filter should pull out easily. Throw away used filter. 4. 5. 3. 6. Press the Lever-Action Lock (or Side-Lock Latch) down while pushing the drawer side to the upright position. 7. Latch the drawer side by pushing up the Lever-Action (or Side-Lock Latch). To replace, push the replacement filter into place. Insert the bottom tabs of the Air Filter Cover and push in until the side tabs snap into place.
5. Wash the inside of the cabinet with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth. 6. To replace the drawer, grasp it by the sides and insert the rollers onto the tracks. 7. Lift the front of the drawer and push it in fully past the stops. TROUBLESHOOTING Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
ASSISTANCE OR SERVICE Before calling for assistance or service, please check "Troubleshooting." It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance. This information will help us to better respond to your request. If you need replacement parts If you need to order replacement parts, we recommend that you only use factory specified replacement parts.
KITCHENAID ®COMPACTOR WARRANTY ONE-YEAR FULL WARRANTY For one year from the date of purchase, when this compactor is operated and maintained according to instructions attached to or furnished with the product, KitchenAid will pay for factory specified replacement parts and repair labor costs to correct defects in materials or workmanship. Service must be provided by a KitchenAid designated service company. KitchenAid will not pay for." 1.