Installation guide

2. Remove two screws attaching access panei and bvver
panei to dishwasher using a 1/4" hex socket, nut driver
or PMHips screwdriven
3. Remove paneis and set paneis aside on a protective
surface,
lower
panel
clip
4. Check that grounding clip is
attached to the lower panel,
water inlet valve
5. ApplyTeflon x tape or pipe
joint compound to 90 ° elbow
fitting and connect fitting to
water inlet valve.
& Tighten elbow until snug, and
be sure that it faces to the rear,
7. Remove terminal box cover. Pull appliance wires
through hole in terminal box. Do not untie the knot in
the wires,
- if you are direct wiring: install a U.h-listed/CSAo
certified clamp connector to the terminal box. if using
conduit, use a U.hqisted/CSAocertified conduit
connector.
- if you are installing a power supply cord kit, do so
nov,,,,following kit instructions,
dishwasher
wires --...
\
cable clamp connector
HeJpfuJTip: Put cardboard under dishwasher until it is
installed in cabinet opening.The cardboard will help
protect floor covering during installation,
8. Measure height of cabinet opening
from underside of countertop to
floor where dishwasher will be
installed (you need the lowest
point). Check chart for that height
opening. Put wheels in the required
position.
wheel
Number of
Minimum Wheel
turns on
cutout height position front leg
34" (86.4 cm) 1 10
34-1/4" (87 cm) 2 5
34-I/2" (87.6 cm) 3 0
8,
Turn both front leveler legs to the same
height.
If the minimum cutout height is less than
34" (86.4 cm), the rear wheels can be
removed for additional clearance.This will
allow the dishwasher to fit into a 33-7/8"
(86 cm) high cutout, but the dishwasher
wiii be more difficult to move into
position, if the wheels are removed,
protect the floor when moving the dishwashen
frontleg
If you have built-up floors
1. Measure height of opening
from underside of
countertop to built-up
floor, if the height is at
bast 33-3/4" (85.7 cm), the
dishwasher will fit into the
opening without
modification to the
countertop or flooring,
2. Put wheels in position 1
and turn the front leveler
legs up all the vva%
3,
/ countertop
33-3/4"
(85.7 cm)
min.
shim &) t°?
Add shims as needed in the area shown to bring
dishwasher up to proper height.
NOTE: Shims must be securely attached to floor to
prevent their movement when the dishwasher is
operated.
shim shim
2-3/4" 6"
(7.0cm) (15,2 cm) (ZOcm)
lO