Installation guide

Option C, Waste disposer - with air gap
Waste disposer _ with air gap |
~Screw-type clamps
[Pr Large Silver drain
: } hose clamp.
Rubber hose
connector
(ue
Drain hose
= [. Drain trap
. Using a hammer and screwdriver,
knock plug into disposer.
UC
. Use needle-nose pliers to remove
plug.
. Connect black end of drain hose to air
gap and cut if needed. (Do not cut
ribbed section.)
. Attach drain hose to air gap with large
silver drain hose clamp (provided).
Use pliers to squeeze clamp open and
move into position. If the drain hose
was cut, use a 1144" to 2" (3.8 to
5 cm) screw-type clamp (not
provided).
. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
— Large’silver drains
hose clamp :
Rubber hose
connector
Drain hose
1. Connect black end of drain hose to air
gap and cut if needed. (Do not cut
ribbed section.)
2. Attach drain hose to air gap with large
silver drain hose clamp (provided).
Use pliers to squeeze clamp open and
move into position. lf the drain hose
was cut, use a 114" to 2" (3.8 to 5 cm)
screw-type clamp (not provided).
3. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.
Install Moisture Barrier
(under a wood countertop)
Install moisture barrier
(under a wood countertop)
L
Moisture
barrier
1. Make sure the area under the cabinet is clean and dry
for installation of the moisture barrier.
2. Remove the backing of the moisture barrier and apply
to underside of the countertop along the front edge of
the counter
Prepare Dishwasher
AWARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
AWARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1 | Put dishwasher on its back