Installation

2. Take the original upper hinge, ip it 180 degrees, and place it

in the lower hinge position on the opposite side, resting on the

cabinet hinge screws (i.e. the upper right hinge is now the

lower left hinge).

NOTE: The extensions on the hinges should always face

inside, not outside.

3. Take the original lower hinge, ip it 180 degrees, and place it

in the upper hinge position on the opposite side resting on the

cabinet hinge screws.

4. Both hinges should be resting on the cabinet hinge screws.

Make sure that all screws are fully tightened. Take hinge pin

and place it in the new top hinge (originally at bottom hinge).

5. Place screw cap covers on all open screw holes. Screw cap

covers must also be placed at the original locations of the

hinges.

Reversing the Side Caps

1. Place the door on a at surface, steel side up.

2. Unscrew TORX

†

screws on non-hinged side.

3. Take the original upper end cap, ip it 180 degrees, and place

it on the lower hinge position on the non-hinged side (i.e. the

upper right end cap is now the lower left end cap).

NOTE: If using a custom panel door, side caps can only be

slid out from the installation bracket horizontally.