Owner's Manual
Table Of Contents
- ICE MAKER SAFETY
- Ice Maker Safety
- IMPORTANT CONSUMER INFORMATION
- Important Consumer Information
- ICE MAKER MAINTENANCE AND CARE
- How Ice Maker Works
- Normal Sounds
- Water Filtration System
- Interior Cleaning
- Exterior Cleaning
- Vac Extn Time Without Use
- INSTALLATION INSTRUCTIONS
- Unpack Ice Maker
- Location Requirements
- Electrical Requirements
- Drain Connection Requirements
- Drain Pump Installation (on some models)
- Water Supply Requirements
- Connect Water Supply
- Connecting the Drain
- Leveling and Securing
- Custom Wood Panel
- Auxiliary Grille Installation
- SECURITE DE LA MACHINE A GLACONS
- Sécurité de la machine à glaçons
- RENSEIGNEMENTS IMPORTANTS POUR LE CONSOMMATEUR
- Renseignements importants pour le consommateur
- ENTRETIEN ET REPARATION DE LA MACHINE A GLACONS
- Comment utiliser la machine à glaçons
- Sons normaux
- Système de filtration d’eau
- Nettoyage de l’intérieur
- Nettoyage des surfaces externes
- Vacances ou longue période d’inutilisation
- INSTRUCTIONS D'INSTALLATION
- Déballage de la machine à glaçons
- Exigences d’emplacement
- Electrical Requirements
- Exigences concernant le raccordement au drain
- Installation de la pompe de vidange (sur certains modèles)
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- Raccordement de la vidange
- Leveling and Securing
- Panneau de bois personnalisé
- Installation de la grille auxiliaire
11
Drain Pump Installation
NOTE: Do not kink, smash, or damage tubes or wires during
installation.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug ice maker or disconnect power.
2. Remove rear panel. See “Rear Panel” illustration for screw
locations. Pull rear panel away from the drain tube and
discard. For standard model, discard the rear panel. For
custom panel model, set aside the rear panel (it will be reused
in a later step).
Rear Panel
A. Screw Iocations for standard model
B. Screw Iocations for custom panel model
3. Remove the old drain tube and clamp attached to the ice
maker bin.
NOTE: Discard old drain tube and clamp.
4. Install new drain tube (5/8" I.D. x 5 1/8") from ice maker bin to
drain pump reservoir inlet using new adjustable clamps. See
“Drain Tube” illustration.
NOTE:
� Do not kink.
� Trim tube length if required.
Drain Tube
A. 7/8" adjustable
hose clamp
B. Drain tube (ice
bin to drain
pump)
C. 7/8" adjustable hose clamp
D. Drain pump reservoir inlet
5. Slide drain pump into the ice maker base on the right side.
The pump mounting tab should slip into the rectangular slot in
the ice maker base. It will be necessary to tip the pump slightly
to slip into the slot. See “Drain Pump Mounting Tab Slot”
illustration.
Drain Pump Mounting Tab Slot
A. Mounting tab slot