Owner's Manual
Table Of Contents
- ICE MAKER SAFETY
- Ice Maker Safety
- IMPORTANT CONSUMER INFORMATION
- Important Consumer Information
- ICE MAKER MAINTENANCE AND CARE
- How Ice Maker Works
- Normal Sounds
- Water Filtration System
- Interior Cleaning
- Exterior Cleaning
- Vac Extn Time Without Use
- INSTALLATION INSTRUCTIONS
- Unpack Ice Maker
- Location Requirements
- Electrical Requirements
- Drain Connection Requirements
- Drain Pump Installation (on some models)
- Water Supply Requirements
- Connect Water Supply
- Connecting the Drain
- Leveling and Securing
- Custom Wood Panel
- Auxiliary Grille Installation
- SECURITE DE LA MACHINE A GLACONS
- Sécurité de la machine à glaçons
- RENSEIGNEMENTS IMPORTANTS POUR LE CONSOMMATEUR
- Renseignements importants pour le consommateur
- ENTRETIEN ET REPARATION DE LA MACHINE A GLACONS
- Comment utiliser la machine à glaçons
- Sons normaux
- Système de filtration d’eau
- Nettoyage de l’intérieur
- Nettoyage des surfaces externes
- Vacances ou longue période d’inutilisation
- INSTRUCTIONS D'INSTALLATION
- Déballage de la machine à glaçons
- Exigences d’emplacement
- Electrical Requirements
- Exigences concernant le raccordement au drain
- Installation de la pompe de vidange (sur certains modèles)
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- Raccordement de la vidange
- Leveling and Securing
- Panneau de bois personnalisé
- Installation de la grille auxiliaire
18
Custom Wood Panel
Custom Panel Dimensions
If you plan to install a custom overlay panel, you will need to make
the panel yourself or consult a qualified cabinetmaker or
carpenter.
IMPORTANT:
� The thickness of the overlay panel must be 3/4ʺ (1.91 cm).
� Overlay panel must not weigh more than 8 lbs. (3.62 kg).
� Overlay panels weighing more than recommended may cause
damage to your ice maker.
� Match wood grain direction with that of adjacent cabinets.
� Sand panel edges to provide a smooth finish.
� Use moisture sealer on both sides and all edges of the panel
to avoid damage from outside.
Option 1 – Without Hinge-Side Spacer
To allow proper clearance for the door, prepare the custom
overlay panel using the dimensions shown.
Option 2 – With Hinge-Side Spacer
To achieve a flush installation with adjacent cabinets, prepare the
custom overlay panel using the dimensions shown.
Top of Panel
A. Front-visible surface when installed
B. Hinge side
Bottom of Panel
A. Front-visible surface when installed
B. Hinge side