Owner's Manual
Table Of Contents
- ICE MAKER SAFETY
- Ice Maker Safety
- IMPORTANT CONSUMER INFORMATION
- Important Consumer Information
- ICE MAKER MAINTENANCE AND CARE
- How Ice Maker Works
- Normal Sounds
- Water Filtration System
- Interior Cleaning
- Exterior Cleaning
- Vac Extn Time Without Use
- INSTALLATION INSTRUCTIONS
- Unpack Ice Maker
- Location Requirements
- Electrical Requirements
- Drain Connection Requirements
- Drain Pump Installation (on some models)
- Water Supply Requirements
- Connect Water Supply
- Connecting the Drain
- Leveling and Securing
- Custom Wood Panel
- Auxiliary Grille Installation
- SECURITE DE LA MACHINE A GLACONS
- Sécurité de la machine à glaçons
- RENSEIGNEMENTS IMPORTANTS POUR LE CONSOMMATEUR
- Renseignements importants pour le consommateur
- ENTRETIEN ET REPARATION DE LA MACHINE A GLACONS
- Comment utiliser la machine à glaçons
- Sons normaux
- Système de filtration d’eau
- Nettoyage de l’intérieur
- Nettoyage des surfaces externes
- Vacances ou longue période d’inutilisation
- INSTRUCTIONS D'INSTALLATION
- Déballage de la machine à glaçons
- Exigences d’emplacement
- Electrical Requirements
- Exigences concernant le raccordement au drain
- Installation de la pompe de vidange (sur certains modèles)
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- Raccordement de la vidange
- Leveling and Securing
- Panneau de bois personnalisé
- Installation de la grille auxiliaire
19
Custom Panel Installation
1. Remove screws and the top metal bracket using the Phillips
screwdriver and place them aside. Skip this step and go to
step 4 if the door reversal has been completed.
2. Remove the top and bottom end caps using the Phillips
screwdriver and place them aside.
3. Reinstall top metal bracket using screws removed in step 1.
4. Lightly press the custom panel onto the door using double-
sided adhesive tape. Adjust height of the panel to align with
the adjacent cabinetry. Press the panel firmly against door.
5. From inside the door, install the wood screws through the
slotted holes in the metal brackets. Continue to step 11 in the
“Leveling and Securing” section.
6. Adjust the panel side to side to achieve a desired gap on both
sides. Install the remaining screws through the door bracket
into the panel.
NOTE: Be sure that the panel is aligned with adjacent cabinet
before installing the remaining screws to secure the door
panel.