Installation Instructions
Table Of Contents
- Ice maker SAFETY
- INSTALLATION INSTRUCTIONS
- Unpack the Ice Maker
- Vacation or Extended Time Without Use
- Location Requirements
- Electrical Requirements
- Water Supply Requirements
- Drain Connection Requirements
- Door Reversal
- Drain Pump Installation (on some models)
- Connect Water Supply
- Leveling and Securing
- Custom Wood Panel
- Connecting the Drain
- Auxiliary Grill Installation
- Deep Clean
- SÉCURITÉ DE LA MACHINE À GLAÇONS
- INSTRUCTIONS D’INSTALLATION
- Déballage de la machine à glaçons
- Vacances ou longue période d’inutilisation
- Exigences d’emplacement
- Spécifications électriques
- Spécifications de l’alimentation en eau
- Exigences concernant le raccordement au drain
- Inversion de la porte
- Installation de la pompe de vidange (sur certains modèles)
- Raccordement à la canalisation d’eau
- Mettre de niveau et sécuriser
- Panneau de bois personnalisé
- Raccordement de la vidange
- Installation de la grille auxiliaire
- Nettoyage en profondeur
- SEGURIDAD DE LA FÁBRICA DE HIELO
- INSTRUCCIONES DE INSTALACIÓN
- Cómo desempacar la máquina de hielo
- Vacaciones o tiempo prolongado sin uso
- Requisitos de ubicación
- Requisitos eléctricos
- Requisitos del suministro de agua
- Requisitos para la conexión del desagüe
- Cambio del sentido de apertura de la puerta
- Instalación de la bomba de desagüe (en algunos modelos)
- Conexión del suministro de agua
- Nivelado y asegurado
- Panel de madera personalizado
- Conexión del desagüe
- Instalación de la rejilla auxiliar
- Limpieza intensa
5
Door Reversal
1. Unplug the ice maker or disconnect power.
2. Remove the screws attaching top and bottom hinge covers
using an 3/16" hex driver.
3. Using pliers, remove the hinge covers from the top and
bottom hinges.
NOTE: Save the hinge covers for future use. Reinstall the
hinge covers if product is removed from cabinet installation.
4. Lay down the ice maker as shown in the illustration. Be sure
to cover the oor with cardboard or hardboard to avoid
damaging it.
5. Remove the screws holding the stainless steel panel from the
bottom of the door. Set the stainless steel panel and screws
aside. For custom panel model, Remove the screws and the
top metal bracket using the Phillips screwdriver.
Place them aside.
6. Remove the plastic screw cover from the inside of the hinges
and set aside.
7. Remove the top and bottom plastic end caps from the door.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Crush Hazard
Articulated hinges are self closing and many pinch
points exist prior to cabinet installation.
Do not remove hinge covers until product is ready to
be installed.
Failure to follow these instructions can result in crush,
cut, or pinch injuries.
WARNING
A
A. Hinge cover