Installation Instruction
12
Install Range Hood
1. Using two or more people, lift the hood liner into the cabinet
until it snaps into the 4 hooks located on the mounting
brackets. The hood liner will remain suspended.
2. Attach the 4.2 x 8 mm (8) screws into the slotted openings.
Do not tighten screws.
3. Center the canopy in the cabinet. Align the bottom of
the canopy with the bottom of the cabinet. Install the
4.2 x 8 mm T20
®
screws into the mounting bracket
and tighten all mounting screws.
4. Place the lower canopy assembly in the front side of the
cabinet and slide it through the bracket as shown in drawing.
5. Open perimetric panel and remove the metal grease lters
from the lower canopy assembly.
6. Secure the lower canopy assembly to the hood usingthe
4x15 mm and the 4.5 x 13 mm screws as depicted
inthediagram below to fasten the panel. Tighten to secure.
7. Plug lamps and control wire connectors from the lower
canopy assembly into the connectors located inside the
hood liner.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
A
C
B
A. Cabinet
B. Hood liner canopy assembly
C. Screws - 4.2 x 8 mm (8)
A. Screws - 4 x 15 mm (4)
B. Screws - 4.5 x 13 mm (3)
A
B
A. Control wire
B. Motor box wire
A. Lamp wire
B. Motor box wire
A AB B