iMPORTANT: Read and save these instructions. Quick Reference Table of Contents: Pages [] Before you start [] Product dimensions [] Cabinet dimensions iMPORTANT: [] Venting requirements installer: Leave Installation instructions with the homeowner. [] Electrical requirements [_-[] Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector's use.
Your safety and the safety of others is very important. We have provided many important safety messagesin this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazardsthat can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING". These words mean: You can be killed or seriously injured if you don't follow instructions.
12-1/32" (3&6 cm} 12" (30.5cm) 18-3/16" (46.2 cm} Y 25-3/16' (64 cm) _ . 30" 36" 42" 48" (76.2cm) hood: 29-7/8" (91.4 cm) hood: 35-7/8" (106.7 cm) hood: 41-7/8" (121.9 cm) hood: 47-7/8" (75.9cm) (91.1 cm) (106.4 cm) (121.6 cm) 18" (45.7 cm) rain, (76.2 cm) rain. bottom ,py to cooking surface of c_earance upper cabinet to countertop Vent system must terminate to the outside. Do not terminate the vent system in an attic or other enclosed area. Do not use 4-inch (10.2 cm) laundry-type wall caps.
Venting methods This canopy range hood is factory set for vertical venting. For rear vent applications, the blower must be turned inside the range hood so that the blower vents to the rear as indicated. The blower is turned by removing two screws on each side of the blower, rotating the blower with the exhaust opening facing the rear and then replacing the screws. The exhaust cover(s) must be moved to block the unused opening(s). The blower must be converted before installing the range hood.
important: Observe all governing codes and ordinances. separate 15-amp circuit, fused on both sides of the Ene. it is the customer's responsibility: Do not ground to a gas pipe. • To contact a quaEfied electrical installer. • To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 - latest edition*, or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 - latest edition** and all local codes and ordinances.
Vent and Electrical openings 2-7/8" (7.5 cm) 2-7/8" (7,5 cm) 3-1/4" 1-1/8" (2.9 cm) All vent openings are x 10" (8.3 cm x 25,4 cm) 2-7/8" (7.5 cm) 2-7/8" (7.5 cm Electrical opening (24.6 crn) 6-3/32" (15.5 cm) 30" (76.2 cm) hood 36" (91.4 cm) hood 42" (106.7 cm) hood 6-3/32" (15.5 cm) , i 48" (121.9 cm) hood 5m The hood attaches to the wall with the mounting screws located as shown. For the 30" (76.2 cm) and 36" (91.4 cm) models, there are two mounting screws. For the 42" (106.
2[] b _ if chimney extension is used: Attach the extension brackets as shown. 10-5/8" Excessive ceiling (27 cm} /_///_/////v//////I///// T _ _ | . _ ! ! I I i _J !\ I i i/ brackets 8-1/8" (20.6 23" (58.4 crn) era) 8-1/8" //I (20.6 cm) max. 12" (30.5 cm) rain. i top of hood Make sure that the screws are securely fastened to the wall. Weight Hazard Use two or more people to move and install range hood. Failure to do so can result in back or other injury.
16[] installthe filters. • Removethe filters from the box andremovethe white protective coatingfromthe filters. Note:Usetwo handsto install filter,oneto pull andturn the knob,the otherto hold the filter in placeso that it doesn'tfall onto the cooktop. Grasponeof the filters so that the knobfacesdown andtoward the backof the hood. insertthe filter endwithoutthe knobintothe retainingchannel in the front of the hood.
Replacing lamps: the Halogen 36" (91.4 crn) and 42" (106,7 crn) hoods shown. Opening the canopy hood control panel: The hood controls are located on the right-hand underside of the canopy. Filters: The filters should be washed frequently. Place metal filters in dishwasher or hot detergent solution to clean. To remove filters: controls ,\ Cleaning Note: Use two hands to remove filters, one to pull and turn the knob, the other to hold the filter so that it doesn't fall onto the cooktop. \ \ • Pull kn
t_ovAc I..JMi_IN For 30" (76.2 cm), 36" (91.4 cm) and 42" (106.7 cm) hoods t_ VAC U_ KITCHENAID ®VENTILATION For 48" (121.9 cm) hoods iN WARRANTY ONE YEAR LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, KitchenAid or KitchenAid Canada (hereafter "KitchenAid') will pay for factory specified parts and repair labor to correct defects in materials or workmanship.
To avoid unnecessary service calls, please check the "Check Operation" section. It may save you the cost of a service call. If you still need help, follow the instructions below. if you need assistance or service in U.S.A. Call the KitchenAid Customer interaction Center toll-free at 1-800-235-0665. Our consultants are available to assist you.
Before calling for assistance check the "Check Operation" you the cost of a service call. help, follow the instructions or service, please section. It may save If you still need below. If you need assistance or service 1.If the problem is not due to one of the items listed in "Check Operation"t... Contact the dealer from whom you purchased your appliance, or call the KitchenAid Canada Customer Interaction Center toll-free, 8:30 a.m.- 6 p.m. (EST), at 1-800-235-0665. in Canada 2. If you need servicer..