Quick Start Manual

Replacing the Incandescent Light Bulb

Turn off the range hood and allow the light bulb to cool.

1. Disconnect power.

2. Squeeze the plastic lens cover and remove it from the hood.

3. Screw light bulb into socket.

4. Replace lens cover by squeezing cover and inserting tabs

into slots.

5. Reconnect power.

If new light does not operate, make sure the lamp is inserted

correctly before calling service.

WIRING DIAGRAM

A. Light bulb socket

B. Lens cover

0.9 ±10% A

50 ±10% Watts

22.3 ±10% Ohms

13.4 ±10% Ohms

Motor Characteristics

Power Supply

120 VAC

Frequency

60 Hz

Amperage

Wattage Rating

Motor Resistance

White - Red

White - Black

Light Switch

On - Off

Motor Switch

Low - Off - High

Speed 2

Common

Speed 1

GND

Ground

Screw