Installation Instructions

5. Place the mounting brackets on each corner of the bottom

side of the selected filler strip depth. Use a pair of pliers to fold

the lower end tab of the bracket at the notch so that the tab

acts as a support for the bottom edge of the filler strip.

For 2¹⁄₄" (57 mm) and 2⁵⁄₈" (67 mm) depths, the bracket end

tab should be folded at a 90° angle.

For 1¹⁄₂" (38 mm) depth, the bracket end tab should be folded

at a 45° angle.

NOTE: If the bracket is not flush to the side of the cabinet, use

a piece of wood to fill the gap. A longer screw may be needed.

If the depth determined is 1¹⁄₂" (38 mm), the brackets should

be attached on the 2⁵⁄₈" (67 mm) side. If the depth determined

is 2¹⁄₄" (57 mm), the brackets should be attached on the

2⁵⁄₈" (67 mm) side. If the depth determined is 2⁵⁄₈"(67mm),

the bracket should be attached on the 2¹⁄₄"(57mm) side.

6. Mark the holes on the sides of the cabinet where the brackets

will be mounted.

7. Drill the holes as marked. Mount the brackets onto the sides

of the cabinets with the four #8–18 x ¹⁄₂" screws provided.

8. Remove the adhesive strip cover to expose the adhesive side

of the brackets. Attach the filler strip to the adhesive on the

mounting brackets with selected filler strip depth facing up.

9. Proceed with normal range installation. See Slide-in Range

Installation Instructions.

A. Filler strip

B. Cabinet side

C. Mounting bracket tab

D. Mounting bracket

E. Folded tab for support