Installation Instructions

4
Before You Begin
Tools
Gather required tools and parts before starting
installation. Read and follow the instructions
provided with any tools listed here.
1. Regular screwdriver
2. Phillips screwdriver
3. 7/16" and 1/2" open-end wrenches (or an
adjustable wrench)
4. Pliers
5. 1/4" nut driver
6. Hand drill with 1/4" drill bit
7. Small hand level (optional)
8. Small 3/4" round le
9. Tubing cutter
10. Center punch
11. Hammer
12. Scissors
13. Ruler
14. Step stool (optional)
Components
Remove the contents from the shipping carton
and set them on a table where they can be easily
identied and located.
Do not discard any of the packing material until
all required parts are identied.
Installation notes
For each set of steps shown, refer to the
diagram immediately beside or below the text
for clarication. Some illustrations also contain
legends. Legends are labelled as A, B, or C and
are clearly referenced in each step.
Install the parts as instructed in each step and
corresponding illustration.
QTY DESCRIPTION
1 Ice Maker Top Mount (TM)
1 Pan Ice Cube
1
Wire shelve
Freezer Compartment (FC)
1
Ice Maker Cover
(on Bottom-Mount)
1 Fill Tube Extension TM
1 Water Fill Tube Bottom Mount (BM)
3 7-18 X .500 MHW TLR LSER
1 Instruction Booklet TM/BM (New)
1 Warranty Letter (2206023)