Datasheet

Board Layout:
BBC micro:bit
Edge Connector
On/Off Switch
Inserting a BBC micro:bit:
To use the :GAME Controller, the BBC micro:bit should be inserted firmly into
the edge connector, making sure that the BBC micro:bit LED display is facing in
the same direction as the front of the :GAME Controller.
Examples: For some starter ideas for how to use the controller, go to:
http://www.kitronik.co.uk/5644
:GAME Controller for the BBC micro:bit
www.kitronik.co.uk/5644
Pin Expansion Pads:
Left – Pin 19
Middle – 3.3V
Right – GND
The :GAME Controller is a programmable gamepad-style controller for the BBC
micro:bit, enabling a better gaming experience on the micro:bit itself, or the
ability to control other devices over the micro:bit radio. It features a piezo buzzer
for audio feedback, a vibration motor for haptic feedback, and 6 input buttons. It
also breaks out P19 & P20 to standard 0.1” footprints including voltage and GND
pads. The BBC micro:bit is connected via a card slot connector.
The board is powered by two AA batteries which feed into the 3V and GND
connections to power the connected BBC micro:bit, removing the need to
power the BBC micro:bit separately. To protect the BBC micro:bit if power is
supplied through it, such as with a USB lead, the devices on the :GAME Controller
will not operate.
4 x M3 Mounting
Holes
Fire Button 1
[Pin 15]
Fire Button 2
[Pin 16]
Piezo Buzzer
[Pin 2]
Vibration Motor
[Pin 1]
Pin Expansion Pads:
Left – GND
Middle – 3.3V
Right – Pin 20
Joypad Up
[Pin 8]
Joypad Right
[Pin 13]
Joypad Left
[Pin 12]
Joypad Down
[Pin 14]
Rear: 2 x AA Battery Holders