Datasheet

Electrical Information
Operating Voltage (Vcc) +4.5V (3 x AA batteries – Rechargeable or Alkaline recommended)
Regulated Voltage (supply BBC micro:bit) +3.3V
Max Current (@ rated Vcc)
6A (Total from switched supply)
150mA (Total from 3V output, allowing 100mA for BBC micro:bit)
15mA (Total from BBC micro:bit IO pins at any one time)
Croc-clip Connections
1 x 3.3V Output
1 x +V Output (battery voltage, maximum output 3A)
2 x GND
3 x BBC micro:bit IO Pins (Pins 0, 1 and 2)
1 x ZIP LED Signal Output
2 x Motor Outputs (2 channels each)
Klip Motor Driver for the BBC micro:bit
www.kitronik.co.uk/5655
Inserting the BBC micro:bit:
To use the Klip Motor Driver
board, the BBC micro:bit
needs to be firmly inserted
into the edge connector at
the bottom of the board.
The BBC micro:bit MUST
have the LEDs visible to the
user in order to be
functional, as shown in the
image to the right.
Inserting Batteries:
The Klip Motor Driver
requires 3 x AA batteries to
provide power to the
connected BBC micro:bit
and any extra attached
devices. These are shown
inserted in the correct
orientation in the image to
the left.