Operation Manual

Box contents
• Bluetooth Sele Stick
• Micro USB cable
• Phone holder
• Phone holder grip
Functions
1. Phone holder grip
2. Phone holder height adjustment
3. Phone holder width adjustment
4. Phone holder
5. ¼-inch tripod screw
6. Tripod screw dial
7. Bluetooth Sele Stick head
8. Head side-screw
9. Telescopic section
10. Rubber grip
11. Camera remote button
12. LED indicator
13. Micro USB port
14. Power switch
User Manual
Bluetooth Sele Stick
Please read this manual carefully before use.
Charging
1. Using the micro USB charging cable, connect the micro USB
connector to the micro USB port (13) on the base of the
Bluetooth Sele Stick and the other to a PC USB port or USB
mains charger
2. The LED indicator (12) will illuminate solid red on the base
whilst charging
3. When fully charged the LED indicator (12) will turn off
Operation
1. Turn the Bluetooth Sele Stick on by sliding the power switch (14)
to the ON position
2 Make sure your smartphone is turned on and Bluetooth is
activated
3. Open the Bluetooth settings on your smartphone and connect to
‘KV Sele Stick’
4. Open your smartphone’s camera application
5. Place your smartphone in the provided phone holder, ensuring it
is well secured. Slide the phone holder width adjustment (3) until
a suitable position is achieved
6. Attach the phone holder to Bluetooth Sele Stick by screwing it
onto the ¼-inch tripod screw (5), tighten fully using the tripod
screw dial (6)
7. Adjust the tilt of the Bluetooth Sele Stick head (7) to gain the
desired angle and tighten using the head side-screw (8)
8. Extend the Bluetooth Sele Stick by pulling the telescopic
section outwards (9)
9. Press the camera remote button (11) to take a photo
10. Slide the power switch (14) to the OFF position to turn the
Bluetooth Sele Stick off when nished