Installation Instructions

8 • Using the CT Clock
Using the CT Clock
The clock will be ready to use after downloading the employees. To
punch, the employee will simply present a badge, place an enrolled
finger on the sensor (Model CT72) or use a PIN. Instantly they are
identified and punched In or Out.
To punch with a badge simply move the badge over the illuminated
hand/badge symbol on the on the front of the clock.
Model CT72 allows employees to punch with a finger simply place the
enrolled finger on the sensor. The best method of finger placement is to
roll the finger flat onto the sensor, as shown below.
When the transaction is successful; a confirmation beep will sound, a
text message will appear, a custom audio message may be played, and
the display will turn either green or red indicating a good or bad
transaction.
Employee Transactions
Employees can record transactions or view total information by
presenting a badge, entering a PIN or presenting an enrolled finger.
Clocking IN/Out - Finger Sensor (CT72)
• Place an enrolled finger on the finger sensor of the clock.
• When the finger is verified a confirmation beep will sound, a text
message will appear, a custom audio message may be played,
and the display will turn either green or red indicating a good or
bad transaction.
Clocking IN/Out - Badge
• Move the badge over the badge reader symbol on the front of
the clock.