Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
16 • Enrolling Fingers
• Tap Primary Finger. The Select finger to register screen will
display.
Employees should enroll their dominant finger. To identify the
dominant finger, ask the employee with which finger they use to point.
• Tap the finger to enroll and tap Next. The employee should be
ready to place their finger on the sensor as prompted.
• The employee will be prompted to place and lift their finger on
the sensor a total of 5 times.
• When the employee’s enrollment is complete, choose to enroll
another finger for the same employee or enroll different
employee. If you are finished with enrollments choose
Enrollment Complete.
• The clock is ready to starting accepting punches for the enrolled
employees.