Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
18 • Administrator Functions
Wireless
This menu allows you to configure the Wi-Fi communication settings.
At the clock tap the Settings button and enter the administrator PIN.
• The Administrator Menu screen will display.
• Tap Wireless. The Available Networks screen will display.
• Select Wi-Fi Networking On if it isn’t already.
• Tap the desired wireless network from the list. The WIFI
Passcode screen will display.
• Using the master buttons to enter the passcode for the wireless
network. Note: You may need to contact your network
administrator for wireless passcode information.
• Tap OK when the passcode has been entered. A confirmation
message will display when connected.
• If you want to set the clock’s wireless IP address as a “Static” IP,
tap Advanced.
• The Network Setup screen will display. Turn off DHCP by
tapping the button. The screen will refresh and the fields will
become active.
• Tap IP Address. The IP Address screen will display.
• Using the numeric key pad enter the IP address you want to
assign to the clock and tap OK.
• Do the same for the Subnet Mask and Gateway.
• When finished tap to return to the default screen.
Sync Now
This menu allows you to initiate a manual synchronization between
PayClock Online and the clock.
At the clock tap the Settings button and enter the administrator PIN.
• The Administrator Menu screen will display.
ABC @&% abc 123