Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
26 • Appendix A – Testing the Connection to PayClock Online
Test 2 – Ports used by the clock will tested.
Pass = The test cycle will move to the PayClock Online service
test.
Fail – What should I do if this test fails?
• Open the listed port(s) to traffic.
• Contact your IT department to open the listed port(s) to traffic.
Test 3 – PayClock Online Service used by the clock will tested.
Pass = The test cycle will display a summary of the test.
Fail – What should I do if this test fails?
• Open the listed port(s) to Inbound / Outbound traffic.
• Contact your IT department to open the listed port(s) to traffic.
Notes
The internet test will attempt to ping www.google.com
. If ping is disabled
on the network a false test result could be displayed and may require you
to involve your IT department or someone familiar with your network.
It may be necessary to involve your IT department or someone familiar
with your network if there is a failure with the Ports or PayClock Online
Services test which requires changes to the network / firewall settings.