Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
Appendix B – Installing a Battery • 27
Appendix B –
Installing a Battery
The CT series clock has an optional re-chargeable battery so the clock is
operational during a power failure. Once the power is restored the
battery will automatically re-charge.
• Remove the cover from the battery compartment on the back of
the clock using a Philips head screwdriver.
• Position the battery connector as shown.
• Plug the battery connector into the clock connector.
• Tuck the connector wires and battery into the battery
compartment, being careful not to pinch the wires.
• Insert the cover into the slot and tighten the Philips head screw.
Note: Make sure the wires are not pinched when closing cover.