Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
iv • Contents
Administrator Functions 17
Network .................................................................................... 17
Wireless .................................................................................... 18
Sync Now ................................................................................. 18
Date/Time Setup ...................................................................... 19
Signal-Door Access .................................................................. 19
Device Info................................................................................ 20
Support ..................................................................................... 20
Check for Updates .................................................................... 20
Factory Reset ...................................................................... 21
Troubleshooting the CT Series 22
General Troubleshooting ............................................................ 22
CT Series Troubleshooting ......................................................... 22
Appendix A – Testing the Connection to PayClock
Online 25
Appendix B – Installing a Battery 27
Appendix C – Adjusting Finger Sensitivity 28
Appendix D – Bell Relay Connections 29
Appendix E – Access Relay Connections 34
Appendix F – Add/Edit/Delete Bell Events 36