Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
• 37
• Tap Signal under the Relay Mode.
• Tap Schedule under Signal Events. The Signal Event Schedule
screen will display with all the schedule events.
• Tap on the desired event and make the needed changes.
• Tap OK to save the changes.
• When finished tap to return to the default screen.
Deleting a Bell Event
• From the CT tap Settings and enter the administrator PIN and
tap OK.
• From the Administrator Main Menu tap Signal-Door Access.
• The Signal-Door Access screen will display.
• Tap Signal under the Relay Mode.
• Tap Schedule under Signal Events. The Signal Event Schedule
screen will display with all the schedule events.
• Tap Delete and then Yes to remove the event.
• When finished tap to return to the default screen.