Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
Supervisor Transactions • 13
Adding Punches
Tap the SUPERVISOR button on the clock. The IDENTIFICATION
screen will display.
• Using either a badge, PIN or finger enter supervisor mode.
• At the Employee selection screen, tap on the name of the
desired employee.
• Tap Punches. The Punches screen will display.
• Use the left or right arrows to select the desired date and press
the +ADD button.
• Using the up and down arrows set the desired hour and minute
and then tap ADD.
• At the confirmation screen select Yes to add the punch. The
added punch will display on the screen and will be added to the
employee’s timecard.
• When finished tap to return to the default screen.
Viewing Totals
Tap the SUPERVISOR button on the clock. The IDENTIFICATION
screen will display.
• Using either a badge, PIN or finger enter supervisor mode.
• At the Employee selection screen, tap on the name of the
desired employee.
• Tap Totals. The employee’s grand totals for the pay period and
any benefit time will display.
• When finished tap to return to the default screen.
Send Message
Tap the SUPERVISOR button on the clock. The IDENTIFICATION
screen will display.
• Using either a badge, PIN or finger enter supervisor mode.
• At the Employee selection screen, tap on the name of the
desired employee.