Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
Enrolling Fingers • 15
Enrolling Fingers
The CT72 model has a built in optical fingerprint sensor that allows for up
to 2 fingerprints per employee to be enrolled. Employees can punch and
review time balances by scanning their finger.
The Admin or Supervisor have the ability to enroll employee fingerprints.
To enroll a finger, tap the ENROLL button and enter the Admin PIN then
tap OK.
Finger Placement on the Sensor
Proper finger placement is critical to ensure reliable finger reads. The
best method of finger placement is to place the pad of the finger, not the
tip, flat onto the center of the sensor window, as shown below. Apply
gentle pressure and hold the finger on the sensor window until the
senor’s light blinks, then lift the finger.
Reasons the sensor failed to recognize an employee
• The finger was positioned incorrectly.
• The finger moved during the reading.
• The wrong finger was used.
• The finger was too wet or dry.
• The finger was cut or otherwise changed.
Enrolling Employee Fingers
At the clock tap the ENROLL button and enter the Admin PIN then tap
OK.
• At the Employee selection screen, tap on the name of the
desired employee.
• Tap the Enable icon on the tan bar at the bottom. You know the
fingerprint is enabled when the label changes to Disable.