Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
Administrator Functions • 21
At the clock tap the Settings button and enter the administrator PIN.
• The Administrator Menu screen will display.
• Tap Check for Updates. Please be patient this may take a few
minutes. Follow the on-screen instructions.
• When finished tap to return to the default screen.
Factory Reset
Use caution when selecting this menu item. This menu item will reset the
entire clock to the manufacturer default settings.
All settings, administrators, supervisors, employees and data will
be cleared from the clock; you cannot recover this information.
At the clock tap the Settings button and enter the administrator PIN.
• The Administrator Menu screen will display.
• Tap Factory Reset. The warning screen will display.
• Tap Reset Device if you are sure you wish to reset and clear the
clock.
• The clock will reboot and restart as if it were a new clock that
had never been used.