Installation Instructions
Table Of Contents
- THIS EQUIPMENT COMPLIES WITH FCC REQUIREMENTS
- Package Contents
- Install the CT Series Clock
- PayClock Online
- Using the CT Clock
- Employee Transactions
- Clocking IN/Out - Finger Sensor (CT72)
- Clocking IN/Out - Badge
- Clocking IN/Out - PIN
- Department Transfers - Finger Sensor (CT72)
- Department Transfers - Badge
- Department Transfers - PIN
- Amount Entries - Finger Sensor (CT72)
- Amount Entries - Badge
- Amount Entries - PIN
- Viewing Totals - Finger Sensor (CT72)
- Viewing Totals - Badge
- Viewing Totals - PIN
- Employee Transactions
- Supervisor Transactions
- Enrolling Fingers
- Administrator Functions
- Troubleshooting the CT Series
- Appendix A – Testing the Connection to PayClock Online
- Appendix B – Installing a Battery
- Appendix C – Adjusting Finger Sensitivity
- Appendix D – Bell Relay Connections
- Appendix E – Access Relay Connections
- Appendix F – Add/Edit/Delete Bell Events
- Blank Page
28 • Appendix C – Adjusting Finger Sensitivity
Appendix C –
Adjusting Finger
Sensitivity
With model CT72 if an employee’s finger is mistakenly read as another
employee, you can adjust the sensitivity level by employee.
Example: Joe Smith puts his finger on the sensor but Stan Able shows
as punching on the display. The solution would be to increase Stan’s
security level. Increasing Stan’s security level will lessen the chance of
Stan’s fingerprint being read as another employee.
Adjusting Finger Sensitivity
At the clock tap the ENROLL button and enter supervisor mode.
• At the Employee selection screen, tap on the name of the
desired employee.
• At the Fingerprint screen tap Security Level. The Security screen
will display these settings.
o 1 – Low Sensitivity
o 2 – Medium Low Sensitivity
o 3 – Moderate Sensitivity (default setting)
o 4 – Medium Hi Sensitivity
o 5 – Hi Sensitivity
• Tap on the desired setting.
• Tap Next, the setting will be applied to any fingerprints enrolled
for the selected employee.
• When finished tap to return to the default screen.