Getting Started

ManualsBrandsKlark Teknik ManualsDI BoxesActive DI Box with 48V Pantom Power Supply

Quick Start Guide

DN100

Active DI Box with Extended Dynamic Range

V 1.0

(1) BALANCED LINKED INPUTS – Connect instruments or

line-level equipment to either the ¼" TRS or XLR inputs.

The other ¼" connector can be used as a link-through to

pass the signal to an amplier. When only the XLR input is

used, an impedance of 20 kΩ optimizes use with line-level

sources, otherwise a nominal impedance of 1 MΩ is ideal

for instrument pickups.

(2) OUTPUT – Send the signal to a mixer or recording

interface via balanced XLR cable.

(3) PAD – Press to reduce the input signal by 20 dB for use

with hot signals.

(4) EARTH – Press to separate the input and output grounds,

potentially eliminating earth/ground loops between

equipment on dierent mains supplies.

(5) 48 V LED – Lights when the unit receives sucient

phantom power. Note that the DN100 must be powered to

operate correctly.

(1)

(2) (3) (4) (5)

Summary of content (4 pages)

PAGE 1
Quick Start Guide DN100 Active DI Box with Extended Dynamic Range (1) (2) (1) (2) V 1.0 BALANCED LINKED INPUTS – Connect instruments or line-level equipment to either the ¼" TRS or XLR inputs. The other ¼" connector can be used as a link-through to pass the signal to an amplifier. When only the XLR input is used, an impedance of 20 kΩ optimizes use with line-level sources, otherwise a nominal impedance of 1 MΩ is ideal for instrument pickups.
PAGE 2
DN100 Specifications Inputs Connectors Impedance Max input level Attenuator 2 x 1/4" TRS and 3-pin XLR linked in parallel 1 MΩ nominal, balanced or unbalanced, 20 kΩ (XLR only) 35 dBu (with pad enabled) 20 dB pad Outputs Connector Impedance Max output level Min load 3-pin XLR 50 Ω 15 dBu with 10 kΩ load 600 Ω System Noise Frequency response Distortion (THD + N) -103 dBu, 22 Hz to 22 kHz unweighted, with input terminated by 10 kΩ resistor 20 Hz to 20 kHz, ±1 dB, 10 kΩ load Typically <0.
PAGE 3
Quick Start Guide FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION DN100 Responsible Party Name: Music Tribe Commercial NV Inc. Address: 901 Grier Drive Las Vegas, NV 89118 USA Phone Number: +1 702 800 8290 DN100 complies with the FCC rules as mentioned in the following paragraph: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 4
DN100 LEGAL DISCLAIMER Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners.