Quick Start Guide

ManualsBrandsKlark Teknik ManualsActive DI BoxesActive DI Box with Extended Dynamic Range

Quick Start Guide

DN100

Active DI Box with Extended Dynamic Range

V 1.0

(EN) Controls

(1) BALANCED LINKED INPUTS – Connect instruments or

line-level equipment to either the ¼" TRS or XLR inputs.

The other ¼" connector can be used as a link-through to

pass the signal to an amplier. When only the XLR input is

used, an impedance of 20 kΩ optimizes use with line-level

sources, otherwise a nominal impedance of 1 MΩ is ideal for

instrument pickups.

(2) OUTPUT – Send the signal to a mixer or recording interface

via balanced XLR cable.

(3) PAD – Press to reduce the input signal by 20 dB for use with

hot signals.

(4) EARTH – Press to separate the input and output grounds,

potentially eliminating earth/ground loops between

equipment on dierent mains supplies.

(5) 48 V LED – Lights when the unit receives sucient phantom

power. Note that the DN100 must be powered to operate

correctly.

(1)

(2) (3) (4) (5)

Summary of content (5 pages)

PAGE 1
Quick Start Guide DN100 Active DI Box with Extended Dynamic Range (1) (2) (EN) Controls (1) BALANCED LINKED INPUTS – Connect instruments or line-level equipment to either the ¼" TRS or XLR inputs. The other ¼" connector can be used as a link-through to pass the signal to an amplifier. When only the XLR input is used, an impedance of 20 kΩ optimizes use with line-level sources, otherwise a nominal impedance of 1 MΩ is ideal for instrument pickups.
PAGE 2
DN100 Quick Start Guide 3 (ES) Controles (DE) Bedienelemente (IT) Controlli (SE) Kontroller (1) BALANCED LINKED INPUTS – Conecte instrumentos o equipos de nivel de línea a las entradas TRS o XLR de ¼”. El otro conector de ¼” se puede utilizar como enlace directo para pasar la señal a un amplificador. Cuando solo se usa la entrada XLR, una impedancia de 20 kΩ optimiza el uso con fuentes de nivel de línea; de lo contrario, una impedancia nominal de 1 MΩ es ideal para captaciones de instrumentos.
PAGE 3
4 DN100 Quick Start Guide Specifications Inputs Connectors Impedance Max input level Attenuator 2 x 1/4" TRS and 3-pin XLR linked in parallel 1 MΩ nominal, balanced or unbalanced, 20 kΩ (XLR only) 35 dBu (with pad enabled) 20 dB pad Outputs Connector Impedance Max output level Min load 3-pin XLR 50 Ω 15 dBu with 10 kΩ load 600 Ω System Noise Frequency response Distortion (THD + N) -103 dBu, 22 Hz to 22 kHz unweighted, with input terminated by 10 kΩ resistor 20 Hz to 20 kHz, ±1 dB, 10 kΩ load Typi
PAGE 4
6 DN100 WETTELIJKE ONTKENNING Music Tribe aanvaardt geen aansprakelijkheid voor enig verlies dat kan worden geleden door een persoon die geheel of gedeeltelijk vertrouwt op enige beschrijving, foto of verklaring hierin. Technische specificaties, verschijningen en andere informatie kunnen zonder voorafgaande kennisgeving worden gewijzigd. Alle handelsmerken zijn eigendom van hun respectievelijke eigenaren.
PAGE 5