KT-2A Classic Leveling Amplifier with Vacuum Tubes, Optical Attenuator and MIDAS Transformers Quick Start Guide
KT-2A Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
4 KT-2A Consignes de sécurité Les points repérés par ce symbole portent une tension électrique suffisante pour constituer un risque d’électrocution. Utilisez uniquement des câbles d’enceintes professionnels de haute qualité avec fiches Jack mono 6,35 mm ou fiches à verrouillages déjà installées. Toute autre installation ou modification doit être effectuée uniquement par un personnel qualifié.
6 KT-2A Instruções de Segurança Importantes Aviso! Terminais marcados com o símbolo carregam corrente elétrica de magnitude suficiente para constituir um risco de choque elétrico. Use apenas cabos de alto-falantes de alta qualidade com plugues TS de ¼" ou plugues com trava de torção pré-instalados. Todas as outras instalações e modificações devem ser efetuadas por pessoas qualificadas.
8 KT-2A Quick Start Guide KT-2A – Controls (EN) Controls (1) (2) (3) (4) (8) (9) (5) (10) (6) (11) (7) (1) LIMIT/COMPRESS switch affects the compression ratio, going from a fixed compression ratio in Compress mode, and shifting to a near-infinite ratio in Limit mode. (2) PRE-EMPHASIS trimmer adjusts the sidechain that the compressor responds to, but does not affect the audio directly in any way.
10 KT-2A Quick Start Guide 11 Other important information Specifications Audio Input Type XLR, ¼" TRS, transformer balanced Impedance 600 Ω, balanced and unbalanced Maximum input level +20 dBu, balanced and unbalanced CMRR at 1 kHz Typically -80 dB Audio Output Type XLR, ¼" TRS, transformer balanced Impedance 70 Ω, balanced and unbalanced Maximum output level +18 dBu, balanced and unbalanced System Specifications Frequency response 10 Hz to 20 kHz, ±1 dB Noise at unity gain -87 dBu,
12 KT-2A Quick Start Guide FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION KLARK TEKNIK KT-2A Responsible Party Name: MUSIC Group Research UK Limited Address: Klark Industrial Park, Walter Nash Road, Kidderminster. Worcestershire. DY11 7HJ. England. Phone Number: +44 1562 741515 KT-2A This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
14 KT-2A Quick Start Guide 15
klarkteknik.
