user manual

HELIX DN9848E Remote Control Software
User Guide
86
6 Select the IP address of the HELIX DN9848E
unit you wish to connect to this port, for
example, “10.20.100.61”.
7 Make sure Echo is set to Generic Echo Off.
8 Click OK to accept port change, or Cancel to decline.
9 Assign port to device by selecting device
in List of Devices and selecting port in the
available ports appropriate to device in
drop down list (right-hand side), for
example, “Unit 1” .
The name of the assigned port will appear
under the Assigned Port column (highlighted
in yellow opposite).
10 Click OK .
Your system should now be ready for online operation, as described in section 3.5. Successful
communication with the HELIX DN9848E units is indicated by ‘rotating’ symbols at the bottom
right-hand corner of the LCD panel (“T1R1” → “T/R/” → “T―R―”).