Operation Manual

16
Installation
The fireplace must not be used until it is securely fastened to the wall. When choosing a location for your
electric fireplace, ensure that the general instructions are followed. For best results, install the electric fireplace
away from direct sunlight and dust.
Handling and Unpacking
• The installation should be carried out by two adults to avoid injury or damage. If for any reason it is conside-
red too heavy, please obtain assistance.
• When lifting the fireplace, always keep your back straight. Bend your legs and not your back. Avoid twisting
at the waist. It is better to reposition your feet.
• Avoid upper body I top heavy bending. Always bend from the knees rather than the waist. Do not lean for-
ward or sideways while handling the heater.
• Always grip the heater with the palm of the hand. Do not use the tips of fingers for support.
• Always keep the heater as close to the body as possible. This will minimize the cantilever action.
• Use gloves to provide additional grip.
• Unpack the package and lift the product gently out of the box, put it on a flat surface with the front panel
facing up.
Safety Warnings
• Do not connect this heater to a programmer, timer, separate remote control system or any other device that
switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
• Do not use this heater in the immediate surroundings of a bath, shower or swimming pool.
• Always make sure the electrical socket is accessible and located adjacent to but not above the heater.
• This heater must be located against the wallz.