Material Safety Data Sheet

09/05/2014Revision:
09/19/2014Printed:
Page: 3
Klean-Strip VM&P Naphtha
SAFETY DATA SHEET
03/17/2014Supersedes Revision:
4. FIRST AID MEASURES
Inhalation:
If user experiences breathing difficulty, move to air free of vapors. Administer oxygen or
artificial respiration until medical assistance can be rendered.
Skin Contact:
Irritation may result. Immediately wash with soap and water.
Eye Contact:
Immediately flush with water, remove any contact lenses, continue flushing with water for
at least 15 minutes, then get medical attention.
Ingestion:
Do not induce vomiting. Call you local poison control center, hospital emergency room,
or physician immediately for instructions.
Emergency and First Aid
Procedures:
Call your local poison control center for further information.
Note to Physician:
5. FIRE FIGHTING MEASURES
Flash Pt:
69.00 F Method Used: TAG Closed Cup
Self-contained respiratory protection should be provided for fire fighters fighting fires in
buildings or confined areas. Storage containers exposed to fire should be kept cool with
water spay to prevent pressure build-up. Stay away from heads of containers that have
been exposed to intense heat or flame.
Fire Fighting Instructions:
Product will normally float on water.
Flammable Properties and
Hazards:
Autoignition Pt:
47.50 F
Explosive Limits:
LEL: 0.9 UEL: 6.7
OSHA Class IB
Use carbon dioxide, dry powder, or foam.
Suitable Extinguishing Media:
Solid streams of water may be ineffective and spread material. Product will normally float
on water.
Unsuitable Extinguishing
Media:
6. ACCIDENTAL RELEASE MEASURES
Cleanup:
Keep unnecessary people away; isolate hazard area and deny entry. Stay upwind, out
of low areas, and ventilate closed spaces before entering. Shut off ignition sources;
keep flares, smoking or flames out of hazard area.
Small Spills:
Take up liquid with sand, earth or other noncombustible absorbent material and place in
a plastic container where applicable.
Large Spills:
Dike far ahead of spill for later disposal.
Steps To Be Taken In Case
Material Is Released Or
Spilled:
7. HANDLING AND STORAGE
Read carefully all cautions and directions on product label before use. Since empty
container retains residue, follow all label warnings even after container is empty.
Dispose of empty container according to all regulations. Do not reuse this container.
Do not use this product near any source of heat or open flame, furnace areas, pilot
Precautions To Be Taken in
Handling:
Licensed to W.M. Barr and Company
GHS format