Installation Instructions

Once cabinet connector installation locations have

been determined, insert cabinet connectors and fasten

using a Phillips head screwdriver until tight. We suggest

using cabinet connectors in each corner of the uprights.

Once the connectors are installed, remove clamps.

CLOSET UPRIGHTS

DOORS, DRAWERS, CLOSET RODS & OTHERS

Note: If cover panel is required between closet bases,

cabinet connectors will not be needed.

Once all closet bases have been installed and secured

to the wall, begin building the configurations. Install

any remaining shelves, drawer kits, hinges and any

accessories.

DOOR AND DRAWERS

Use step-by-step instructions included with hinges

and drawer kits. Refer to pages 7-8 to determine hole

locations your configurations will use.

DRESSER TOPS

A dresser top shelf will sit on top of a cam lock shelf. If

desired, you may silicone this shelf into place.

CLOSET ROD

Install the closet rod supports into the pre-drilled holes of

the uprights. Set the rod onto the supports.

Note: The closet rod will need to be cut to length for 15"

and 24" closet bases. Tape off length and cut using a

hacksaw.