Product Brochure

Introduction – Wire Mesh Grips
Klein mesh pulling-grips are used for pulling overhead or underground cable, for
stringing service or communication lines into buildings, for pulling wire through
conduit, and for general underground construction.
Klein grips may be used for pulling bare or insulated wires, and wire rope.
They install quickly and easily, and are designed to pass readily through ducts,
conduit, blocks, and sheaves.
Klein grips are reusable and do not damage the cable because pulling tension
remains uniform along the length of the grip. The mesh will fit either a single
cable, or a bundle of cables.
Klein pulling grips are woven of galvanized steel – strong and long lasting.
General Application Information
KPJ junior-duty series is used for small-job requirements where pulling tensions
are low. Typical uses are to connect insulated building wire bundles to pulling
tape, and pull through conduit.
KPL light duty grips are economical for applications such as industrial plant
wiring and rewiring jobs, and in underground electrical construction where
pulling tensions are low.
KSRK light-duty, slack-pulling grips are split mesh, single-weave design with rod
closure for quick installation. Application areas similar to KSSK series, except
mesh lengths are shorter and for lower pulling loads.
KPM medium-duty grips are flexible and easily handled; ideal for use where the
exceptional strength of heavy-duty grips is not required.
KSCK medium-duty slack-pulling grips with closed double-weave mesh are used
for final placement of underground cable where cable end is available, or for
removing cable. Standard lengths are used in restricted space for short pulls.
Where space is not restricted, longer lengths are used for higher pulling loads.
KSSK medium-duty slack-pulling grip applications are similar to the KSCK series
except they are used where cable end is not available. Double-weave split mesh
has lace closure.
KP heavy-duty grip series are recommended for underground installations.
KPS heavy-duty grip series are also recommended for underground installations.
An additional feature of the KPS includes "rotating eye" to allow twists in the cable
to spin out during slack periods.
Prefix Letter Code
KPJ Pulling, Junior-Duty, Closed-Mesh,
Single-Weave, Light Duty, Flexible Eye
KPL Pulling, Closed-Mesh,
Single-Weave, Flexible Eye
KSRK Slack-Pulling, Light-Duty, Split-Mesh,
Single-Weave, Rod Closure, Offset Flexible Eye
KPM Pulling, Medium-Duty, Closed-Mesh,
Double-Weave, Flexible Eye
KSCK Slack-Pulling, Meduim Duty, Closed-Mesh,
Double-Weave, Offset Flexible Eye
KSSK Slack-Pulling, Meduim Duty, Split-Mesh,
Double-Weave, Lace Closure, Offset Flexible Eye
KP Pulling, Heavy-Duty, Closed-Mesh,
Double-Weave, Flexible Eye
KPS Pulling, Heavy-Duty, with Rotating Eye,
Closed-Mesh, Double-Weave
Catalog Number Explanation
KPS — 050 — 2
Grip Type* and
Mesh
Cat. No.**
Size Code
Final Digit, if any, refers to
mesh length range or actual
dimension.
* See Prefix Letter Code explanation.
** On Junior-duty grips, initial digit "0" is omitted in Cat. No.
Example:
Cat. No. KPS-050-2 is a heavy-duty pulling grip with a rotating eye, for use
with cable diameters from .50" to .61", with medium-length mesh.
See Wire-Mesh Grip Warnings on page 289
www.kleintools.com
288
Wire Pulling Grips