Buying Guide

Can Wrench
•
Two tools in one saves space in your pouch
•
One end opens telephone box fasteners, the other end tightens nuts on
binding-post terminals
•
The 7/16" socket has a black finish and the 3/8" socket has a silver finish
•
Sockets are 1-1/4" (32 mm) deep to fit over long binding posts and are
thin-walled for easy access into tight areas
•
Socket ends are color-coded for quick identification of socket sizes
•
Hex-socket design enables using a wrench to obtain extra torque
•
High-impact, break-resistant handle for long and dependable service
•
Sockets are heat-treated, alloy steel
68005
Cat. No. Size Length Handle Diameter Weight
68005 3/8" and 7/16"
Hex Nut
7" (177.8 mm) 1" (25.4 mm) 5.6 oz. (159 g)
Bell System Type Wrench

•
End openings sized to NEMA hardware specifications
•
Silver painted finish
3146B
Bell System B, L, and H Chicago
®
Grips
•
All are equipped with chain, toggle and shackle - keeps the grip
from falling off of cable
•
1659-5AT is designed to pull 1/4" (6.35 mm) figure-8 telephone
cable. Also has serpentine jaw
1659-5AT
Cat. No. Size Length Weight
3146B Large End: 1-1/16" (27.0 mm) and
1-3/16" (30.2 mm) Small End: 11/16"
(17.5 mm) and 7/8" (22.2 mm)
13" (330.2 mm) 1.8 lbs. (0.82 kg)
Cat. No. Type Cable Diameter Jaw Length Weight
5,000 lbs. (2,268 kg) Maximum Safe Load
1659-5AT "B" Strand Puller 0.20" to 0.37"
(5.08 to 9.4 mm)
5" (127.0 mm) 6.7 lbs.
(3.04 kg)
8,000 lbs. (3,629 kg) Maximum Safe Load
1684-5AT "L" Strand Puller 0.218" to 0.550"
(5.54 to 13.97 mm)
5" (127.0 mm) 6.9 lbs.
(3.13 kg)
1692-5A
T "L" Strand Puller 0.218" to 0.550"
(5.54 to 13.97 mm)
5" (127.0 mm) 6.6 lbs.
(2.99 kg)
15,000 lbs. (6,803 kg) Maximum Safe Load
1628-16AT "H" Strand Puller 0.31" to 0.62"
(7.87 to 15.75 mm)
7-1/4" (184.2 mm) 15.8 lbs.
(7.17 kg)
*1692-5AT (larger clamping force than 1684-5AT)
Steel Strand Wire Pulling Grips
WARNING: Grips are to be used for temporary installation,
not for permanent anchorage.
WARNING: Do not exceed rated capacity.
WARNING: When used on/or near energized lines, ground,
insulate, or isolate grip before pulling.
WARNING: Before each use, clean jaw area and inspect grip for
proper operation to avoid slippage.
WARNING: Always match proper size and type of grip to application.
Telecom Tools
See page 310 for additional information on warnings.
www.kleintools.com
30