Buying Guide
Table Of Contents
4000907
Digital Circuit Breaker Finder
•
Quickly, accurately, and automatically find the corresponding
circuit breaker of any standard 120V outlet
•
For use on powered circuits only
•
Does not require interruption of service
•
Bright green arrow and loud beep provide clear indication of
correct breaker
•
Strong transmitter reaches distances up to 1000 ft. (305 m)
•
Optional Circuit Breaker Finder Accessory Kit (Cat. No. 69411)
refer to page 200: Find breakers of light fixtures and bare
wires with light socket and alligator clip adapters
ET300
Cat. No. Overall Length Overall Height Overall Width Weight
ET300 Receiver: 6" (152.4 mm)
Transmitter: 2-51/64" (71.0 mm)
29/32" (23.0 mm) Receiver: 2" (50.8 mm)
Transmitter: 1-57/64" (48.0 mm)
0.20 lb (0.09 kg)
ET60
ET250
ET260
Electronic Voltage Testers
•
Cat. No. ET60 includes test leads
•
Cat. Nos. ET250 and ET260 include test leads and batteries
•
ET60 is a solid-state, low impedance, electronic voltage tester that
measures AC/DC voltages up to 600V. It does NOT require batteries - it
is powered by the applied voltage. This tough meter design is water and
dust resistant, and withstands a 9.8 ft (3 m) drop.
•
ET250 Digital AC/DC Voltage and Continuity Tester is a solid-state,
digital voltage and continuity tester that measures AC/DC voltages
up to 600V and tests for continuity. Additionally, the ET250 also tests
GFCI protected circuits to verify that the GFCI device is functioning
appropriately. This tester includes a backlight and integrated flashlight
for working in reduced ambient lighting conditions. It automatically
selects the measurement mode, and auto-powers on when a voltage/
continuity measurement is attempted. This tough meter design is water
and dust resistant, and withstands a 9.8 ft (3 m) drop.
•
ET260 Digital AC/DC Voltage and Continuity Tester is a solid-state,
digital voltage and continuity tester that measures AC/DC voltages up to
690V and tests for continuity. The tester includes a backlight, integrated
flashlight, and has built in test lead holders. It automaticaly selects the
measurement mode and auto-powers on when a voltage/continuity
measurement is attempted. This tough meter design is water and dust
resistant, and withstands a 9.8 ft (3 m) drop
Cat. No. Batteries Voltage Standard Overall Length Overall Width Weight
ET60 Not Required 12 to 600 V AC/DC CAT IV 600V 5-43/64" (144.1 mm) 2-11/32" (59.5 mm) 3.2 oz (92 g)
ET250 3 x AAA 2 to 600V AC/DC CAT IV 600V 6-1/16" (154.0 mm) 2-5/16" (58.7 mm) 6.0 oz (170 g)
ET260 3 x AAA 2 to 690V AC/DC CAT IV 600V; CAT III 690V 6-1/16" (154.0 mm) 2-5/16" (58.7 mm) 6.0 oz (170 g)
Electrical Testers
NEW!
NEW!
NEW!
NEW!
See page 295 for additional information on warnings.
www.kleintools.com
198
Electrical Test & Measurement