Use and Care Manual

ManualsBrandsKlein Tools ManualsClamp LightsCordless Utility Bucket LED Light (Tool Only)

ENGLISH

OPERATING INSTRUCTIONS

FUEL GAUGE BATTERY PACKS

Some DeWALT battery packs include a fuel gauge which consists of three green LED

lights that indicate the level of charge remaining in the battery pack.

75 – 100% charged

51 – 74% charged

<50% charged

Pack needs to be charged

For more information regarding fuel gauge battery packs, please call 1-800-4-DeWalt

(1-800-433-9258) or visit www.dewalt.com.

To actuate the fuel gauge, press and hold the fuel

gauge button

. A combination of the three green

LED lights will illuminate designating the level of

charge left. When the level of charge in the battery

is below the usable limit, the fuel gauge will not

illuminate and the battery will need to be recharged.

NOTE:

The fuel gauge is only an indication of the approximate charge left on the

battery pack, according to the indicators below. It does not indicate tool functionality

and is subject to variation based on product components, temperature and end-user

application.

OPERATING INSTRUCTIONS

To operate the main light, press the power

button

, Product will cycle through modes in the

following sequence.

1st button press: Area light mode ON

2nd button press: Area and spot mode ON

3rd button press: Spot mode ON

4th button press: OFF

In any mode, a button press >2 seconds will power

the unit OFF. The next button press after direct

power off will return to last used mode.

To operate the secondary interior light, press the

power button

, product will turn ON after 1st button

press. 2nd button press will turn the light OFF.

TO USE THE BUCKET CLAMP,

1. Press the clamp release button

, this will extend the clamp to the fully open position.

2. Place bucket light over edge of bucket.

3. Slide clamp forward allowing it to lock into position tightly on bucket.

4. Release clamp when re-positioning bucket light. Do not attempt to re-position

bucket light while clamp is fully closed.

STORAGE AND TRANSPORTATION:

1. Hold unit by handle portion during transport.

2. Light head should be rotated to the rear facing position to protect lens during

transport.

3. Ensure clamping mechanism is in the closed position.

TO REMOVE THE BATTERY:

1. Lift the battery compartment latch and open the battery compartment.

2. Push in the release buttons and pull the battery pack out of the tool.

3. Close the battery compartment and secure the latch.