Cut Sheet

286
www.kleintools.com
All dimensions are in inches and (millimeters).
See page 296 for additional information on warnings.
Steel Construction &
Work@Height Tools
Connecting Bars
Hex and Round Bars
3242
Gooseneck Bar
•
Provides extra leverage when positioning steel members and
aligning bolt holes.
•
Forged fit-up bar is pointed on one end.
•
Chisel-end is at a 45° angle to give even greater leverage.
3245
GN3243
Barrel-Type Drift Pins
Cat. No. Maximum
Diameter
Point
Diameter
Overall
Length
Weight
(lbs.)
3260 11/16" (18 mm) 5/16" (8 mm) 7-1/2" (191 mm) .60
3261 13/16" (21 mm) 7/16" (11 mm) 8" (203 mm) .85
3262 15/16" (24 mm) 1/2" (13 mm) 8" (203 mm) 1.10
3263 1-1/16" (27 mm) 9/16" (14 mm) 8" (203 mm) 1.50
•
Machined from quality alloy steel.
•
Tapers are uniform and blend into body diameter.
•
Tough, drop-forged steel will properly end-pein in use.
•
Heat-treated for strength.
•
Black finish for rust resistance.
Cat. No. Hex Diameter Length Weight (lbs.)
3242 3/4" (19 mm) 30" (762 mm) 3.50
3243 7/8" (22 mm) 36" (914 mm) 6.00
3244 3/4" (19 mm) 24" (610 mm) 2.50
Straight Chisel-End
3240 3/4" (19 mm) 30" (762 mm) 3.80
Cat. No. Diameter Length Weight (lbs.)
3245 3/4" (19 mm) 30" (762 mm) 3.30
3246 7/8" (22 mm) 36" (914 mm) 5.50
3247 3/4" (19 mm) 24" (610 mm) 2.50
3248 7/8" (22 mm) 30" (762 mm) 4.30
Straight Chisel-End
3241 3/4" (19 mm) 30" (762 mm) 3.20
Cat. No. Diameter Length Weight (lbs.)
GN3243 7/8" (19 mm) 29-1/4" (743 mm) 4
WARNING: Lock collar should ONLY be used on Klein 7/8" connecting bars
Lock collar must be installed on connecting bar before using holder.
Connecting Bar Holder with Lock Collar
•
Lock Collar fits Klein
®
7/8" (22 mm) connecting Bars
(Cat. Nos. 3246 & 3248)
•
Leather steel construction.
•
Tunnel loop allows for weight distribution on belt.
•
Fits belts up to 3-1/2" (89 mm) wide.
•
Lock collar (Cat. No. 5459C) included; also available separately.
5459SLVR
3261
5459C
Cat. No. Belt Connection Belt Width Overall Size Weight (lbs.)
5459SLVR tunnel loop up to 3-1/2"
(89 mm)
3" x 6-3/4"
(76 mm x 171 mm)
.40
Replacement Collar
5459C .30
For additional construction tools, see Mining Tools section
WARNING: Always wear approved personal protective equipment.
•
Provides extra leverage when positioning steel members and aligning bolt holes.
•
Forged fit-up bar is pointed on one end.
•
Chisel-end is at a 15° angle to give greater leverage.
Hex BarsRound Bars