Owner's Manual
SPEAKER CONNECTION
IMPORTANT! Turn your amplier or receiver OFF
before connecting your speakers. This action will
avoid damage that could result from accidental
shorting of the speaker cables.
You can use bare wire or banana, pin, or spade
connectors with your loudspeaker binding posts.
Tighten the posts rmly by hand but do not over
tighten!
Correct polarity (or phase) is critical for proper
imaging and bass performance. Connect one
speaker at a time to ensure proper connection.
The red (+) amplier terminal connects to the red
(+) speaker terminal. The same applies to the
black (–) terminals. Make sure all wires are rmly
fastened. Repeat this connection procedure for
each speaker. Once connected, it is a good idea
to go back and double-check each connection for
correct polarity.
BREAK-IN
Your KLH Model Three loudspeakers will sound great right out of the box. But since your new speakers include many moving
parts, these parts need time to adjust to one another. Therefore, some amount of “break-in” is necessary for your speakers to
sound their best. KLH recommends playing your speakers at a moderate volume for at least 8 hours before any critical listening.
PLACING THE MODEL THREE ON SLANT RISER