Service Manual

Table Of Contents

 Indoor Unit Disassembly 9 

2.2 Electrical parts (Antistatic gloves must be worn.)

Note: Remove the front panel (refer to 1. Front panel) before disassembling electrical parts.

Procedure Illustration

1) Cut the ribbon by a shear, then pull

out the coil temperature sensor (T2)

(see Fig. 14).

2) Remove one ﬁ xing screw of the

electronic control box and two screws

used for the ground connection (see

Fig. 14).

3) An upward force is maintained until

the cover of electronic control box is

removed (see Fig. 15).

Fig. 14

Fig. 15

Note: This section is for reference only. Actual unit appearance may vary.

Ribbon

T2 Sensor

Ground Screws