Service Manual

 Outdoor Unit Disassembly 36 
6. PCB board 7
Procedure Illustration
1) Remove the screws of the top cover.
(1 screws) (see Fig. 6.1).
2) Unfix the hooks and then open the
electronic control box cover (5
hooks)(see Fig. 6.2).
3) Disconnect the connector for fan
motor from the IPM board (see Fig.
6.3).
4) Remove the connector for the
compressor (see Fig. 6.3).
Fig. 6.1
Fig. 6.2
Fig. 6.3
Note: This section is for reference only. Actual unit appearance may vary.
Compressor