Service Manual

 Outdoor Unit Disassembly 37 
Procedure Illustration
5) Pull out the wire connected with the
terminal. (see Fig. 6.4).
6) Pull out connectors of the condenser
coil temp. sensor(T3),outdoor ambient
temp. sensor(T4) and discharge temp.
sensor(TP) (see Fig. 6.4).
7) Disconnect the electronic expansion
valve wire (see Fig Fig. 6.4).
8) Remove the connector for 4-way valve.
(see
Fig. 6.4).
9) Remove the connector for the reactor
(see Fig. 6.4).
10) Then remove the electronic control
box (see Fig. 6.4).
Fig. 6.4
Note: This section is for reference only. Actual unit appearance may vary.
4-Way Valve
Reactor
T3/T4
TP
Terminal