Service Manual

Table Of Contents

 Outdoor Unit Disassembly 43 

3.7 Compressor

WARNING: Evacuate the system and conﬁrm that there is no refrigerant left in the system before removing the

four-way valve and the compressor. (For R32 & R290, you should evacuate the system with the vacuum pump; ﬂush the

system with nitrogen; then repeat the two steps before heating up the brazed parts. The operations above should be

implemented by professionals.)

Note: Remove the panel plate, connection of compressor on PCB (refer to 3.1 Panel plate and 3.2 Electrical

parts) before disassembling sound blanket.

Procedure Illustration

1) Remove the ﬂange nut of terminal cover

and remove the terminal cover (see Fig.

12).

2) Disconnect the connectors (see

Fig. 13)

Fig. 12

Fig. 13

Note: This section is for reference only. Actual unit appearance may vary.

Terminal Cover